KAN-therm: Cabinets



Cabinets

Surface heating and cooling manifolds should be mounted in special installation cabinets which are available in three basic versions: surface-mounted, flush-mounted and covered with glaze.

The design of installation cabinets for surface heating and cooling enables the assembly of manifolds with and without a mixing system. The cabinets also provide space for the electrical strips. Electrical strips are fitted with screws to a specially prepared holes on the mounting rail at the top of the cabinet.
Fast selection of cabinets, depending on the type of manifold, basic equipment and how connection method is presented in the table below:

Type of cabinet Code Height
[mm]
Width
[mm]
Depth
[mm]
Number of circuits
OP manifold manifold
OP+Set-P/Set
-K
OP manifold
with mixing
system
SWN-OP-10/3 1100-OP 710 580 140 2-10 2-7/2-6 2-3
SWN-OP-11/7 1110-OP 710 780 140 11-13 8-11/7-10 4-7
SWN-OP-15/10 1120-OP 710 930 140 14-15 12-14/11-13 8-10
SWPG-OP-10/3 1300G-OP 710 580 110-165 2-10 2-7/2-6 2-3
SWPG-OP-11/7 1310G-OP 710 780 110-165 11-13 8-11/7-10 4-7
SWPG-OP-15/10 1320G-OP 710 930 110-165 14-15 12-14/11-13 8-10
SWP-OP-10/3 1300-OP 750-850 580 110-165 2-10 2-7/2-6 2-3
SWP-OP-11/7 1310-OP 750-850 780 110-165 11-13 8-11/7-10 4-7
SWP-OP-15/10 1320-OP 750-850 930 110-165 14-15 12-14/11-13 8-10