Connecting the elements of System KAN-therm Copper uses the simple, quick, and most importantly, safe (no work with open fire) "Press" technology - consisting of pressing a fitting on a pipe using special crimping tools
All tools for installation of System KAN-therm Copper are easy to use and do not require any special qualifications.
See how easy it is!
There are just a few easy steps to make a correct and tight joint:
Cut the pipe to the required length
To cut the pipes use special roll cutters and make the cut perpendicular to the pipe axis.
Prepare a section of the cut pipe
With a manual chamferer (for diameters 66.7 – 108mm – semi-round file), chamfer the internal and external edge of the cut pipe, remove all chips that could damage the O-ring during assembly.
Check for the presence of the O-ring
and its state in the fitting
the pipe into the fitting to the required depth
Mark the required depth of inserting the pipe into the fitting
It is necessary to achieve the correct strength of the joint.
Place the properly selected jaw
on the fitting and press it.