KAN-therm: KAN-therm installation boxes



KAN-therm installation boxes

Distributors for surface heating shall be mounted in special installation boxes available in three versions: surface– mounted, embedded and clad with glazed tiles.

 

Due to the design of boxes for floor heating distributors can be mounted with or without a mixing device. In boxes there is also room for electrical strips. Electrical strips are attached by screws, which enter into special holes in a mounting strip in the upper part of a box. The Table below allows a fast selection of boxes depending on the distributor type, basic equipment and the way of connection:

 

 

 

Box type Code Height
[mm]

Width
[mm]

Depth
[mm]

Number of circuits
OP distributor

OP+Set-P/Set-K
distributor

OP distributor with a mixer
SWN-OP-10/3 1100-OP 710 580 140 2-10 2-7/2-6 2-3
SWN-OP-11/7 1110-OP 710 780 140 11-13 8-11/7-10 4-7
SWN-OP-15/10 1120-OP 710 930 140 14-15 12-14/11-13 8-10
SWPG-OP-10/3 1300G-OP 710 580 110-165 2-10 2-7/2-6 2-3
SWPG-OP-11/7 1310G-OP 710 780 110-165 11-13 8-11/7-10 4-7
SWPG-OP-15/10 1320G-OP 710 930 110-165 14-15 12-14/11-13 8-10
SWP-OP-10/3 1300-OP 750-850 580 110-165 2-10 2-7/2-6 2-3
SWP-OP-11/7 1310-OP 750-850 780 110-165 11-13 8-11/7-10 4-7
SWP-OP-15/10 1320-OP 750-850 930 110-165 14-15 12-14/11-13 8-10

 

 

 


OP distributor – distributor for series 51A, 55A, 71A and 75A floor heating
OP + Set-P/Set-K distributor - distributor for series 51A, 55A, 71A and 75A floor heating with Set-K angle valves or straight valves type Set-P (2-7/2-6 – number of circuits with Set-K valves/number of circuits with Set-P valves),
OP distributor with a mixing device – distributor with series 73A and 77A mixing device.